Enterasys Matrix 2G4072-52 Configuration Manual page 1321

14.3.8.9 set cep detection-id type
Use this command to specify whether a phone detection group will use H.323, Siemens or SIP as
its phone discovery type.
set cep detection-id id type {h323 | siemens | sip}
Syntax Description
id
h323 | siemens |
sip
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Usage
This command applies only to Siemens, H.323, and SIP phone detection. Cisco
detection uses CiscoDP as its discovery method.
There are currently 3 manual detection types (Siemens, H323, SIP). Under manual
detection configuration, for each of the types, the "Endpoint Phone Type" will be
listed correctly. However, the high and low ports will not reflect default ports for
the "Endpoint Phone Types". The user will have to configure the port low and high
options to match their needs for the Endpoint Phone Type being configured, as
described in
Example
This example shows how to set the phone detection type to H.323 for CEP group 1
Matrix>set cep detection-id 1 type h323
Configuring Convergence End Points (CEP) Phone Detection
Specifies a CEP configuration group ID. This group must
be created and enabled using the set cep detection-id
command as described in
1 - 2147483647.
Specifies the phone type to detect as H.323,Siemens or SIP.
Section 14.3.8.12.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Security Configuration Command Set
Section 14.3.8.8. Valid values are
:
14-111