Enterasys Matrix 2G4072-52 Configuration Manual page 463

Table 6-1 show spantree Output Details (Continued)
Output
Root Forward Delay
Bridge ID MAC Address
Bridge ID Priority
Bridge Max Age
Bridge Hello Time
Bridge Forward Delay
Topology Change Count
Time Since Top Change
Max Hops
What It Displays...
Amount of time (in seconds) the root device spends in
listening or learning mode.
Unique bridge MAC address, recognized by all bridges in
the network.
Bridge priority, which is a default value, or is assigned using
the set spantree priority command. For details, refer to
Section 6.2.1.25.
Maximum time (in seconds) the bridge can wait without
receiving a configuration message (bridge "hello") before
attempting to reconfigure. This is a default value, or is
assigned using the set spantree maxage command. For
details, refer to Section
Amount of time (in seconds) the bridge sends BPDUs. This
is a default value, or is assigned using the set spantree hello
command. For details, refer to
Amount of time (in seconds) the bridge spends in listening
or learning mode. This is a default value, or is assigned
using the set spantree fwddelay command. For details,
refer to Section 6.2.1.37.
Number of times topology has changed on the bridge.
Amount of time (in days, hours, minutes and seconds) since
the last topology change.
Maximum number of hops information for a particular
Spanning Tree instance may traverse (via relay of BPDUs
within the applicable MST region) before being discarded.
This is a default value, or is assigned using the set spantree
mashops command. For details, refer to
Matrix DFE-Platinum and Diamond Series Configuration Guide
Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6.2.1.34.
Section 6.2.1.31.
Section 6.2.1.52.
6-11