Set Multiauth Session-Timeout - Enterasys Matrix 2G4072-52 Configuration Manual

Security Configuration Command Set
Configuring Multiple Authentication

14.3.10.15 set multiauth session-timeout

Use this command to set multiple authentication session-timeout values, for an active session.
set multiauth session-timeout [cep | dot1x | mac | pwa] timeout
Syntax Description
cep | dot1x | mac |
pwa
timeout
Command Defaults
If no authentication type is specified, the timeout value is set for all types.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the session-timeout value for an active session, for cep and mac
authentication to 500 seconds:
Matrix(rw)->set multiauth session-timeout cep 500
Matrix(rw)->set multiauth session-timeout mac 500
This example shows how to set the session-timeout value for an active session, for all the
authentication types to 600 seconds:
Matrix(rw)->set multiauth session-timeout 600
14-150 Matrix DFE-Platinum and Diamond Series Configuration Guide
(Optional) Specifies the authentication type:
•
cep — Enterasys Convergence End Point Authentication
•
dot1x— IEEE 802.1X Port-Based Network Access
Control
•
mac — Enterasys Mac Authentication
•
pwa — Enterasys Port Web Authentication
Number of seconds before session timeout.
Range = 0-65535, if set to zero the session never times out.