Configuring Spanning Tree Port Parameters - Enterasys Matrix 2G4072-52 Configuration Manual

6.2.2

Configuring Spanning Tree Port Parameters

Purpose
To display and set Spanning Tree port parameters, including enabling or disabling the Spanning
Tree algorithm on one or more ports, displaying designated bridge, port and root information,
displaying blocked ports, displaying and setting Spanning Tree port priorities and costs, configuring
edge port parameters, and setting point-to-point protocol mode.
Commands
The commands used to review and set Spanning Tree port parameters are listed below and described
in the associated section as shown.
•
show spantree portenable
•
set spantree portenable
•
clear spantree portenable
•
show spantree portadmin
•
set spantree portadmin
•
clear spantree portadmin
•
set spantree protomigration
•
show spantree portstate
•
show spantree blockedports
•
show spantree portpri
•
set spantree portpri
•
clear spantree portpri
•
set spantree porthello
•
clear spantree porthello
•
show spantree portcost
•
show spantree adminpathcost
•
set spantree adminpathcost
•
clear spantree adminpathcost
(Section 6.2.2.1)
(Section 6.2.2.2)
(Section 6.2.2.3)
(Section 6.2.2.4)
(Section 6.2.2.5)
(Section 6.2.2.6)
(Section 6.2.2.7)
(Section 6.2.2.8)
(Section 6.2.2.9)
(Section 6.2.2.10)
(Section 6.2.2.11)
(Section 6.2.2.12)
(Section 6.2.2.13)
(Section 6.2.2.14)
(Section 6.2.2.15)
(Section 6.2.2.16)
(Section 6.2.2.17)
(Section 6.2.2.18)
Matrix DFE-Platinum and Diamond Series Configuration Guide
Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6-91