Enterasys Matrix 2G4072-52 Configuration Manual page 1156

Routing Protocol Configuration Command Set
Configuring OSPF
retransmit-
interval seconds
transmit-delay
seconds
Command Syntax of the "no" Form
The "no" form of this command removes the virtual link:
no area area-id virtual-link ip-address authentication-key key
no area area-id virtual-link ip-address dead-interval seconds
no area area-id virtual-link ip-address hello-interval seconds
no area area-id virtual-link ip-address retransmit-interval seconds
no area area-id virtual-link ip-address transmit-delay seconds
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to configure a virtual link between OSPF area 0.0.0.2 and ABR network
134.141.7.2:
Matrix>Router1(config)#router ospf 1
Matrix>Router1(config-router)#area 0.0.0.2 virtual-link 134.141.7.2
13-54 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the number of seconds between successive
retransmissions of the same LSAs. Valid values are greater
than the expected amount of time required for the update
packet to reach and return from the interface, and range from
1 to 8192.
Specifies the estimated number of seconds for a link state
update packet on the interface to be transmitted. Valid
values range from 1 to 8192.