Enterasys Matrix 2G4072-52 Configuration Manual page 1169

Table 13-4 show ip ospf interface Output Details
Output
Vlan
Internet Address
Router ID
Network Type
Cost
Transmit Delay
State
Priority
Designated Router
id
Interface addr
Backup Designated
Router id
Timer intervals
configured
Neighbor Count
Matrix DFE-Platinum and Diamond Series Configuration Guide
What It Displays...
Interface (VLAN) administrative status as up or down.
IP address and mask assigned to this interface.
Router ID, which OSPF selects from IP addresses
configured on this router.
OSPF network type, for instance, broadcast.
OSPF interface cost, which is either default, or assigned
with the ip ospf cost command. For details, refer to
Section 13.2.3.4.
The number (in seconds) added to the LSA (Link State
Advertisement) age field.
The interface state (versus the state between neighbors).
Valid values include BACKUPDR (Backup Designated
Router), and DR (Designated Router).
The interface priority value, which is either default, or
assigned with the ip ospf priority command. For details,
refer to Section 13.2.3.5.
The router ID of the designated router on this subnet, if one
exists.
IP address of the designated router on this interface.
IP address of the backup designated router on this interface,
if one exists.
OSPF timer intervals. These are either default, or configured
with the ip ospf retransmit-interval
ip ospf hello-interval
dead interval (Section
timer represents the amount of time a router waits before
initiating a designated router/backup designated router
election. The wait timer changes when the dead interval
changes. The retransmit timer represents the amount of time
between successive transmissions of LSAs (Link State
Advertisements) until acknowledgement is received.
Number of neighbors over this interface.
Routing Protocol Configuration Command Set
(Section
(Section 13.2.3.9), and the ip ospf
13.2.3.10) commands. The wait
Configuring OSPF
13.2.3.7), the
13-67