Enterasys Matrix 2G4072-52 Configuration Manual page 679

port-string
port-string
storage-type
non-volatile |
volatile
vlan vlan
drop | forward
admin-pid
admin-pid
cos cos
syslog enable |
disable
trap enable |
disable
disable-port enable
| disable
Command Defaults
•
•
Command Type
Switch command.
(Optional) If admin-profile is specified, applies this
administratively-assigned rule to a specific ingress port.
Adds or removes this entry from non-volatile storage.
Classifies to a VLAN ID.
Specifies that packets within this classification will be
dropped or forwarded.
If admin-profile is specified, associates this rule with a
policy profile index ID. Valid values are 1 - 1023.
Specifies that this rule will classify to a Class-of-Service
ID. Valid values are 0 - 255, and can be configured using
the set cos settings command as described in
Section
forwarding behavior modification is desired.
Enables or disables sending of Syslog messages on first
rule use.
Enables or disables sending SNMP trap messages on first
rule use.
Enables or disables the ability to disable the ingress port
on first rule use.
If mask is not specified, all data bits will be considered relevant.
If port-string is not specified, rule will be scoped to all ports.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
NOTE: Matrix Series devices with firmware
versions 3.00.xx and higher also support this
alternative command to administratively assign
a profile rule to a port:
set policy port port-string admin-id
8.3.3.21. A value of -1 indicates that no CoS
8-35