Clear Spantree Autoedge - Enterasys Matrix 2G4072-52 Configuration Manual

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6.2.1.41

clear spantree autoedge

Use this command to reset automatic edge port detection to the default state of enabled.
clear spantree autoedge
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset automatic edge port detection to enabled:
Matrix(rw)->clear spantree autoedge
6-54 Matrix DFE-Platinum and Diamond Series Configuration Guide