Enterasys Matrix 2G4072-52 Configuration Manual page 1129

13.2.2.20 receive-interface
Use this command to allow RIP to receive update packets on an interface. This does not affect the
sending of RIP updates on the specified interface.
receive-interface vlan vlan-id
Syntax Description
vlan vlan-id
Command Syntax of the "no" Form
The no use of this command denies the reception of RIP updates:
no receive-interface vlan vlan-id
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to deny the reception of RIP updates on VLAN 2:
Matrix>Router1(config)#router rip
Matrix>Router1(config-router)#no receive-interface vlan 2
Specifies the number of the VLAN to make a receive
interface. This VLAN must be configured for IP routing as
described in Section
Matrix DFE-Platinum and Diamond Series Configuration Guide
Routing Protocol Configuration Command Set
2.3.1.
Configuring RIP
13-27