Configuring Irdp - Enterasys Matrix 2G4072-52 Configuration Manual

13.2.5 Configuring IRDP

Purpose
To enable and configure the ICMP Router Discovery Protocol (IRDP) on an interface. This protocol
enables a host to determine the address of a router it can use as a default gateway.
Commands
The commands used to enable and configure IRDP are listed below and described in the associated
section as shown:
•
ip irdp (Section 13.2.5.1)
•
ip irdp maxadvertinterval
•
ip irdp minadvertinterval
•
ip irdp holdtime
•
ip irdp preference
•
ip irdp address (Section
•
no ip irdp multicast
•
show ip irdp (Section
(Section 13.2.5.2)
(Section 13.2.5.3)
(Section 13.2.5.4)
(Section 13.2.5.5)
13.2.5.6)
(Section 13.2.5.7)
13.2.5.8)
Matrix DFE-Platinum and Diamond Series Configuration Guide
Routing Protocol Configuration Command Set
Configuring IRDP
13-81