Enterasys Matrix 2G4072-52 Configuration Manual page 1088

IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
12.2.9.13 next-server
Use this command to specify the next server in the DHCP server boot process. The next server is
the server the client will contact for the boot file if the primary server is not able to supply it. A next
server is usually specified in a manual DHCP binding configuration in order to provide an IP
address to a BOOTP client and allow the client to receive the TFTP server address when
downloading a boot file image.
next-server primary-ip secondary-ip
Syntax Description
primary-ip
secondary-ip
Command Syntax of the "no" Form
The "no" form of this command removes the secondary server:
no next-server primary-ip secondary-ip
Command Type
Router command.
Command Mode
Any DHCP configuration mode.
Command Defaults
None.
Example
This example shows how to specify 10.20.42.13 as primary and 10.20.100.36 as secondary DHCP
servers:
Matrix>Router1(config)#ip dhcp pool localpool
Matrix>Router1(config-dhcp-pool)#next-server 10.20.42.13 10.20.100.36
12-128 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the IP address of the primary DHCP server.
Specifies the IP address of the secondary DHCP server.