Set Cep Initialize - Enterasys Matrix 2G4072-52 Configuration Manual

14.3.8.13 set cep initialize

Use this command to clear all existing CEP connections for one or more CEP-enabled ports. This
command is similar to the clear cep users command.
set cep initialize [port-string]
Syntax Description
port-string
Command Defaults
If no port-string is specified, all existing CEP connections on all ports are cleared.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to re-initialize CEP ports fe.1.3-5
Matrix>set cep initialize fe.1.3-5
Configuring Convergence End Points (CEP) Phone Detection
(Optional) Specifies the CEP-enabled port(s) to clear
existing CEP connections. This must be a port-string
enabled for CEP using the set cep port command as
described in Section
possible port-string values, refer to
Matrix DFE-Platinum and Diamond Series Configuration Guide
Security Configuration Command Set
14.3.8.6. For a detailed description of
Section
:
4.1.1.
14-115