Show Snmp Targetaddr - Enterasys Matrix 2G4072-52 Configuration Manual

5.3.6.1

show snmp targetaddr

Use this command to display SNMP target address information.
show snmp targetaddr [targetAddr] [volatile | nonvolatile | read-only]
Syntax Description
targetAddr
volatile |
nonvolatile |
read-only
Command Defaults
•
•
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SNMP target address information:
Matrix(rw)->show snmp targetaddr
Target Address Name
Tag List
IP Address
UDP Port#
Target Mask
Timeout
Retry count
Parameters
Storage type
Row status
Table 5-9
(Optional) Displays information for a specific target
address name.
(Optional) When target address is specified, displays
target address information for a specific storage type.
If targetAddr is not specified, entries for all target address names will be
displayed.
If not specified, entries of all storage types will be displayed for a target
address.
shows a detailed explanation of the command output.
Matrix DFE-Platinum and Diamond Series Configuration Guide
SNMP Configuration Command Set
Configuring SNMP Target Addresses
= labmachine
= v2cTrap
= 10.2.3.116
= 162
= 255.255.255.255
= 1500
= 4
= v2cParams
= nonVolatile
= active
5-47