Ip Configuration; Process Overview: Internet Protocol (Ip) Configuration - Enterasys Matrix 2G4072-52 Configuration Manual

This chapter describes the Internet Protocol (IP) configuration set of commands and how to use
them.
ROUTER: Unless otherwise noted, the commands covered in this chapter can be
executed only when the device is in router mode. For details on how to enable router
configuration modes, refer to
12.1 PROCESS OVERVIEW: INTERNET PROTOCOL (IP)
CONFIGURATION
Use the following steps as a guide to configuring IP on the device:
1. Configuring routing interface settings
2. Managing router configuration files
3. Performing a basic router configuration
4. Reviewing and configuring the ARP table
5. Reviewing and configuring broadcast settings
6. Reviewing IP traffic and configuring routes
7. Configuring PIM
8. Configuring Load Sharing Network Address Translation (LSNAT)
9. Configuring Dynamic Host Configuration Protocol (DHCP)
Section
(Section
(Section 12.2.7)
Matrix DFE-Platinum and Diamond Series Configuration Guide

IP Configuration

2.3.3.
(Section 12.2.1)
12.2.2)
(Section 12.2.3)
(Section 12.2.4)
(Section 12.2.5)
(Section 12.2.6)
12
(Section 12.2.8)
(Section 12.2.9)
12-1