Ip Ospf Cost - Enterasys Matrix 2G4072-52 Configuration Manual

13.2.3.4

ip ospf cost

Use this command to set the cost of sending an OSPF packet on an interface. Each router interface
that participates in OSPF routing is assigned a default cost. This command overwrites the default
of 10.
ip ospf cost cost
Syntax Description
cost
Command Syntax of the "no" Form
The "no" form of this command resets the OSPF cost to the default of 10:
no ip ospf cost
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the OSPF cost to 20 for VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip ospf cost 20
Specifies the cost of sending a packet. Valid values range
from 1 to 65535.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Routing Protocol Configuration Command Set
Configuring OSPF
13-37