Configuring Port Traffic Rate Limiting - Enterasys Matrix 2G4072-52 Configuration Manual

9.3.4

Configuring Port Traffic Rate Limiting

Purpose
To limit the rate of inbound or outbound traffic on the Matrix Series device on a per port/priority
basis. The allowable range for the rate limiting is 64 kilobytes per second minimum up to the
maximum transmission rate allowable on the interface type.
Rate limit is configured for a given port and list of priorities. The list of priorities can include one,
some, or all of the eight 802.1p priority levels. Once configured, the rate of all traffic entering or
leaving the port with the priorities configured to that port is not allowed to exceed the programmed
limit. If the rate exceeds the programmed limit, frames are dropped until the rate falls below the
limit.
Commands
The commands to configure traffic rate limiting are listed below and described in the associated
section.
•
show port ratelimit
•
set port ratelimit
•
clear port ratelimit
(Section 9.3.4.1)
(Section 9.3.4.2)
(Section 9.3.4.3)
Matrix DFE-Platinum and Diamond Series Configuration Guide
Port Priority and Rate Limiting Configuration Command Set
Configuring Port Traffic Rate Limiting
9-15