Enterasys Matrix 2G4072-52 Configuration Manual page 1086

IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
12.2.9.11 default-router
Use this command to assign a default router list to DHCP clients.
default-router address [address2...address8]
Syntax Description
address
address2...
address8
Command Syntax of the "no" Form
The "no" form of this command deletes the default router list:
no netbios-name-server
Command Type
Router command.
Command Mode
Any DHCP configuration mode.
Command Defaults
If address2...address8 is not specified, no additional addresses will be configured.
Example
This example shows how to assign a default router at 14.12.1.99 to the "localpool" address pool:
Matrix>Router1(config)#ip dhcp pool localpool
Matrix>Router1(config-dhcp-pool)#default-router 14.12.1.99
12-126 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the IP address of a default router.
(Optional) Specifies, in order of preference, up to 7
additional default router IP address(es).