Area Default Cost - Enterasys Matrix 2G4072-52 Configuration Manual

13.2.3.17 area default cost

Use this command to set the cost value for the default route that is sent into a stub area by an Area
Border Router (ABR). The use of this command is restricted to ABRs attached to stub areas.
area area-id default-cost cost
Syntax Description
area-id
cost
Command Syntax of the "no" Form
The "no" form of this command removes the cost value from the summary route
that is sent into the stub area:
no area area-id default-cost
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to set the cost value for stub area 10 to 99:
Matrix>Router1(config)#router ospf 1
Matrix>Router1(config-router)#area 10 default-cost 99
Specifies the stub area. Valid values are decimal values or IP
addresses.
Specifies a cost value for the summary route that is sent into
a stub area by default. Valid values are 24-bit numbers, from
0 to 16777215.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Routing Protocol Configuration Command Set
Configuring OSPF
13-51