Enterasys Matrix 2G4072-52 Configuration Manual page 1370

Security Configuration Command Set
Configuring Access Lists
14.3.12.1 show access-lists
Use this command to display configured IP access lists when operating in router mode.
show access-lists [number]
Syntax Description
access-list-
number
Command Type
Router command.
Command Mode
Any router mode.
Command Defaults
If number is not specified, the entire table of access lists will be displayed.
Example
This example shows how to display IP access list number 101. This is an extended access list, which
permits or denies ICMP, UDP and IP frames based on restrictions configured with the one of the
access-list commands. For details on configuring standard access lists, refer to
For details on configuring extended access lists, refer to
Matrix>Router1#show access-lists 101
Extended IP access list 101
permit icmp host 18.2.32.130 any
permit udp host 198.92.32.130 host 171.68.225.126 eq
deny ip 150.136.0.0 0.0.255.255 224.0.0.0 15.255.255.255
deny ip 11.6.0.0 0.1.255.255 224.0.0.0 15.255.255.255 2)
deny ip 172.24.24.0 0.0.1.255 224.0.0.0 15.255.255.255
14-160 Matrix DFE-Platinum and Diamond Series Configuration Guide
(Optional) Displays access list information for a specific
access list number. Valid values are between 1 and 199.
Section 14.3.12.3
Section 14.3.12.4.
.