Set Flowlimit Shutdown - Enterasys Matrix 2G4072-52 Configuration Manual

14.3.15.10 set flowlimit shutdown

Use this command to enable or disable the flow limit shut down function. When enabled, this allows
ports configured with a "disable" action to shut down. For information on using the set flowlimit
limit command to configure set a disable action on a port, refer to
set flowlimit shutdown {enable | disable}
Syntax Description
enable | disable
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to enable the flow limit shut down function:
Matrix(rw)->set flowlimit shutdown enable
Enables or disables the flow limit shut down function.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
Section 14.3.15.3.
14-203