Enterasys Matrix 2G4072-52 Configuration Manual page 1158

Routing Protocol Configuration Command Set
Configuring OSPF
13.2.3.21 redistribute
Use this command to allow routing information discovered through non-OSPF protocols to be
distributed in OSPF update messages.
redistribute {rip | static [metric metric value] [metric-type type-value]
[subnets] [tag] | {connected [route-map id-namber] [metric metric value]
[metric-type type-value] [subnets] [tag tag]}
Syntax Description
rip
static
metric metric
value
metric-type type
value
subnets
tag tag
connected
route-map
id-number
13-56 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies that RIP routing information will be redistributed
in OSPF.
Specifies that non-OSPF information discovered via static
routes will be redistributed. Static routes are those created
using the ip route command detailed in
(Optional) Specifies a metric for the connected, RIP or
static redistribution route. This value should be consistent
with the designation protocol.
(Optional) Specifies the external link type associated with
the default connected, RIP or static route advertised into
the OSPF routing domain. Valid values are 1 for type 1
external route, and 2 for type 2 external route.
(Optional) Specifies that connected, RIP or static routes
that are subnetted routes will be redistributed.
(Optional) Specifies that tagged routes will be
redistributed in OSPF.
Specifies that non-OSPF information discovered via
directly connected interfaces will be redistributed. These
are routes not specified in the OSPF network command as
described in Section
(Optional) Redistributes according to a route map
associated with a connected interface or IP address. Valid
values are 1 - 99 and must match a configured ACL
number as described in
Section
13.2.3.2.
Section 14.3.12.2.
12.2.6.8.