Enterasys Matrix 2G4072-52 Configuration Manual page 970

IP Configuration Command Set
Configuring Routing Interface Settings
12.2.1.5 ip address
Use this command to set, remove, or disable a primary or secondary IP address for an interface.
Each Matrix Series routing module or standalone device supports up to 256 routing interfaces, with
up to 50 secondary addresses (200 maximum per router) allowed for each primary IP address.
ip address ip-address ip-mask [secondary]
Syntax Description
ip-address
ip-mask
secondary
Command Syntax of the "no" Form
The "no" form of this command removes the specified IP address and disables the
interface for IP processing.
no ip address ip-address ip-mask
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
If secondary is not specified, the configured address will be the primary address
for the interface.
Example
This example sets the IP address to 192.168.1.1 and the network mask to 255.255.255.0 for VLAN
1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip address 192.168.1.1 255.255.255.0
12-10 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the IP address of the interface to be added or
removed.
Specifies the mask for the associated IP subnet.
(Optional) Specifies that the configured IP address is a
secondary address.