Enterasys Matrix 2G4072-52 Configuration Manual page 1045

12.2.8.9 faildetect (real server)
Use this command to configure which method (type) is used to detect whether an LSNAT server is
up or down.
faildetect {ping-int seconds ping-retries number | app-int seconds app-retries
number | type [both | ping | app]}
Syntax Description
ping-int seconds
ping-retries
number
app-int seconds
app-retries
number
type both | ping |
app
Command Syntax of the "no" Form
The "no" form of this command resets the fail detection configuration to a ping
interval of 5 seconds, a TCP application interval of 15 seconds and a retry number
of 4 for both ping and app retries:
no faildetect
Command Type
Router command.
Command Mode
SLB Real Server Configuration mode: Matrix>Router1(config-slb-real)#
Command Defaults
If not specified, ping will be chosen as the fail detection type.
Configuring Load Sharing Network Address Translation (LSNAT)
Specifies an ICMP ping failure detection interval in
seconds. Valid values are 1 - 200. Default is 5 seconds.
Specifies the number of times an ICMP ping failure will
result in a retrial. Valid values are 1 - 200. Default is 4.
Specifies a TCP application failure detection interval in
seconds. Default is 15 seconds.
Specifies the number of times a TCP application failure will
result in a retrial. Default is 4.
Specifies that the failure detection mechanism will be ping,
TCP application, that both methods will be used. This
determines whether of not a real server in a server farm will
be pinged for connectivity before being selected as a
potential LSNAT server.
Matrix DFE-Platinum and Diamond Series Configuration Guide
IP Configuration Command Set
12-85