Enterasys Matrix 2G4072-52 Configuration Manual page 1054

IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
12.2.8.15 virtual
Use this command to configure a virtual server IP address.
virtual ip-address {tcp | udp} port [service service-name]
Syntax Description
ip-address
tcp | udp
port
service
service-name
Command Syntax of the "no" Form
The "no" form of this command clears the virtual server configuration:
no virtual ip-address
Command Type
Router command.
12-94 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies an IP address for the virtual server.
Specifies TCP or UDP as the protocol used by the virtual
server.
Specifies a TCP or UDP port number (0 through 65535) or
port name to be used by this virtual server. Specifying 0
indicates all ports can be used by this virtual server, and
should be used only with sticky session persistence
configuration. (See
Considerations" on page 12-71)
The following port name keywords may be used:
ftp — File Transfer Protocol, port 21
telnet — Telnet, port 23
www — World Wide Web, port 80
(Optional) When TCP is specified, allows the specified
service to also be accessed through this virtual server IP
address.
Currently, only ftp may be specified.
NOTE: If sticky session persistence is configured with the
persistence level command
parameter is not needed.
"Sticky Persistence Configuration
(Section 12.2.8.18), this