Enterasys Matrix 2G4072-52 Configuration Manual page 680

Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
Command Mode
Read-Write.
Examples
This example shows how to use
with policy number 1. This rule will filter Ethernet II Type 1526 frames to VLAN 7:
Matrix(rw)->set policy rule 1 ether 1526 vlan 7
This example shows how to use
with policy profile number 5. This rule specifies that UDP frames from source port 45 will be
filtered to VLAN 7:
Matrix(rw)->set policy rule 5 udpportsourceip 45 vlan 7
This example shows how to configure classification rule 2 as an administrative profile and assign
it to ingress port fe.1.1:
Matrix(rw)->set policy rule admin-profile port fe.1.1 port-string fe.1.1
admin-pid 2
This example shows how to classify all Ethernet II Type 1526 frames to administrative policy
profile 2:
Matrix(rw)->set policy rule admin-profile ether 1526 admin-pid 2
Table 8-3 provides the set policy rule data values that can be entered for a particular classification
type, and the mask bits that can be entered for each classifier associated with that parameter.
hen there
Table 8-3 Valid Values for Policy Classification Rules
Classification Rule Parameter
ether
icmptype
8-36 Matrix DFE-Platinum and Diamond Series Configuration Guide
Table 8-3 to create (and enable) a classification rule to associate
Table 8-3 to create (and enable) a classification rule to associate
data value
Type field in Ethernet II
packet: 1536 - 65535
ICMP Type: a.b
mask bits
1- 16
1- 16