12.2.9.19 client-name
Use this command to assign a name to a DHCP client.
client-name name [client-class name]
Syntax Description
name
client-class name
Command Syntax of the "no" Form
The "no" form of this command deletes a client name:
no client-name name
Command Type
Router command.
Command Mode
Any DHCP configuration
Command Defaults
If client-class is not specified, none will be assigned.
Example
This example shows how to assign "soho1" as a client name in "clientclass1":
Matrix>Router1(config)#ip dhcp pool localpool
Matrix>Router1(config-dhcp-pool)#client-name soho1 client-class clientclass1
Configuring Dynamic Host Configuration Protocol (DHCP)
Specifies a name for a DHCP client.
NOTE: The client name should not include the
domain name.
(Optional) Specifies the class to which this client will be
assigned. Must be configured using the client-class name as
described in
Section
mode.
Matrix DFE-Platinum and Diamond Series Configuration Guide
IP Configuration Command Set
12.2.9.17.
12-135