Show Policy Capability - Enterasys Matrix 2G4072-52 Configuration Manual

8.3.2.2

show policy capability

Use this command to display all policy classification capabilities supported by your Matrix Series
device. The output of this command shows a table listing classifiable traffic attributes and the type
of actions, by rule type, that can be executed relative to each attribute. Above the table is a list of
all the actions possible on this device.
The left-most column of the table lists all possible classifiable traffic attributes. The next two
columns from the left indicate how policy profiles may be assigned, either administratively or
dynamically. The next four columns from the left indicate the actions that may be performed. The
last three columns indicate auditing options.
An x in an action column for a traffic attribute row indicates that your system has the capability to
perform that action for traffic classified by that attribute.
show policy capability
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display your Matrix Series device's policy classification capabilities.
In this case, Matrix DFE-Platinum Series capabilities are shown. Refer to
description of the parameters displayed:
Policy Classification Configuration Command Set
Matrix DFE-Platinum and Diamond Series Configuration Guide
Assigning Classification Rules to Policy Profiles
Section 8.3.2.4 for a
8-29