Ip Ospf Hello-Interval - Enterasys Matrix 2G4072-52 Configuration Manual

Routing Protocol Configuration Command Set
Configuring OSPF
13.2.3.9

ip ospf hello-interval

Use this command to set the number of seconds a router must wait before sending a hello packet to
neighbor routers on an interface. Each Matrix Series routing module or standalone device can
support communications between up to 60 neighboring routers.
ip ospf hello-interval seconds
Syntax Description
seconds
Command Syntax of the "no" Form
The "no" form of this command sets the hello interval value to the default (10
seconds for broadcast and point-to-point networks, 30 seconds for non-broadcast
and point-to-multipoint networks):
no ip ospf hello-interval
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the hello interval to 5 for VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip ospf hello-interval 5
13-42 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the hello interval in seconds. Hello interval must
be the same on neighboring routers (on a specific subnet),
but can vary between subnets. This parameter is an unsigned
integer with valid values between 1 and 65535.