Enterasys Matrix 2G4072-52 Configuration Manual page 1107

13.2.2.2 network
Use this command to attach a network of directly connected networks to a RIP routing process, or
to remove a network from a RIP routing process.
network ip-address
Syntax Description
ip-address
Command Syntax of the "no" Form
The "no" form of this command removes the network from the RIP routing
process:
no network ip-address
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to attach network 192.168.1.0 to the RIP routing process:
Matrix>Router1(config)#router rip
Matrix>Router1(config-router)#network 192.168.1.0
Specifies the IP address of a directly connected network that
RIP will advertise to its neighboring routers.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Routing Protocol Configuration Command Set
Configuring RIP
13-5