Enterasys Matrix 2G4072-52 Configuration Manual page 1034

IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
Table 12-8 LSNAT Configuration Task List and Commands (Continued)
Task
•
(Optional) Allow specific clients direct access
to a real server without using LSNAT.
Configure global direct access:
•
(Optional) Allow all clients to directly access all
services provided by real servers EXCEPT FOR
those services configured to be accessed
through a configured virtual server. (See
"Configuring Direct Access to Real Servers"
page 12-71 for more information.)
Display or clear server load balancing connections and statistics:
•
(Optional) Display server load balancing
connections and statistics.
•
(Optional) Display SLB active sticky
persistence connections.
•
(Optional) Clear server load balancing
connections or statistics.
Display and set chassis-based LSNAT limits:
(Optional) From the switch CLI, display and set
chassis-based LSNAT address translation limits.
NOTE: These commands must be
executed from the switch CLI.
12-74 Matrix DFE-Platinum and Diamond Series Configuration Guide
Use these commands...
allow accessservers
ip slb allowaccess_all
on
show ip slb conns
show ip slb stats
show ip slb sticky
clear ip slb (Section
show router limits
set router limits
clear router limits
(Section 12.2.8.19)
(Section 12.2.8.20)
(Section 12.2.8.21)
(Section 12.2.8.22)
(Section 12.2.8.23)
12.2.8.24)
(Section 12.2.8.25)
(Section 12.2.8.26)
(Section 12.2.8.27)