Enterasys Matrix 2G4072-52 Configuration Manual page 1322

Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
14.3.8.10 set cep detection-id address
Use this command to set an H.323, Siemens, or SIP phone detection group's IP address or mask. By
default, H.323 will use 224.0.1.41 as its IP address and Siemens will have no IP address configured.
set cep detection-id id address { ip-address | unknown }
mask {mask | unknown }
NOTE: This command applies only to Siemens, H.323, and SIP phone detection. Cisco
detection uses CiscoDP as its discovery method.
Syntax Description
id
address ip-address |
unknown
mask mask |
unknown
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set an IP address of 10.1.1.3 and mask for detection group 1:
Matrix>set cep detection-id 1 address 10.1.1.3 mask 255.255.0.0
14-112 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies a CEP configuration group ID. This group
must be created and enabled using the set cep
detection-id command as described in
Section 14.3.8.8. Valid values are 1 - 2147483647.
Sets the IP address for CEP detection, or sets the
address to unknown.
Set the IP mask for CEP detection, or sets the mask to
unknown.