Enterasys Matrix 2G4072-52 Configuration Manual page 1206

Routing Protocol Configuration Command Set
Configuring VRRP
13.2.6.10 enable
Use this command to enable VRRP on an interface.
enable vlan vlan-id vrid
NOTE: Before enabling VRRP, you must set the other options described in this section.
Once enabled, you cannot make any configuration changes to VRRP without first
disabling it using the no enable vlan command.
Syntax Description
vlan vlan-id
vrid
Command Syntax of the "no" Form
The "no" form of this command disables VRRP on an interface:
no enable vlan vlan-id vrid
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to enable VRRP on VLAN 1, VRID 1:
Matrix>Router1(config)#router vrrp
Matrix>Router1(config-router)#enable vlan 1 1
13-104 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the number of the VLAN on which to enable
VRRP. This VLAN must be configured for IP routing as
described in Section
Specifies the Virtual Router ID (VRID) associated with the
vlan-id. Valid values are from 1 to 255.
2.3.2.