Start A Manual Script - Digi IX10 User Manual

Applications
If once is enabled, rebooting the device will cause the script to run again. The only way to re-
run the script is to:
Remove the script from the device and add it again.
n
Make a change to the script.
n
Disable once.
n
10. Sandbox is enabled by default. This option protects the script from accidentally destroying the
system it is running on.
(config system schedule script 0)> sandbox true
(config system schedule script 0)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Start a manual script

You can start a script that is enabled and configured to have a run mode of Manual. See

Web
1. Log into the IX10 WebUI as a user with Admin access.
2. At the Status page, click Scripts.
The Scripts page displays:
3. For scripts that are enabled and configured to have a run mode of Manual, click Start Script
to start the script.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
IX10 User Guide
Start a manual script
670