Checking And Adding Engine Oil - MacDon M2170 Unloading And Assembly Instructions

3. M2170: Ensure that clamps (A) and clamp (B) on the
turbocharger intake duct are secure. Clamp (B) is secure
when screw tip (C) extends beyond the housing and
Belleville washers (D) are almost flat.
4. M2260: Ensure that clamp (A) and three clamps (B) on the
turbocharger intake duct are secure. Clamps (B) are secure
when screw tip (C) extends beyond the housing and
Belleville washers (D) are almost flat.

4.1.3 Checking and Adding Engine Oil

The engine oil level will need to be inspected before the engine can be operated. It may be necessary to add oil to the
crankcase.
Checking engine oil level
1. Locate engine oil dipstick (A) on the right side of the
windrower. Turn the dipstick counterclockwise to unlock it.
Remove the dipstick.
2. Wipe the dipstick clean. Reinsert the dipstick it into the
dipstick tube.
262175
PERFORMING PREDELIVERY CHECKS
Figure 4.4: Constant Torque Clamps – M2170
Figure 4.5: Constant Torque Clamps – M2260
Figure 4.6: Engine Oil Dipstick Location
51
A
C
A
C
B E E B
A
D
B
D
Revision A