VACON® 100 FLOW
Application Guide
3.
To select Local or Remote, use the arrow buttons Up and Down again. To accept the selection, push the [OK] button.
4.
If Remote control place is changed to Local, that is, the keypad, give a keypad reference.
After the selection, the display goes back into the same location where it was when the [FUNCT] button was push-
ed.
2.4.4.3 Going into the Control Page
It is easy to monitor the most important values in the Control page.
See more information about Keypad Reference in
display shows the frequency reference that cannot be edited. The other values on the page are Multimonitor values. These values
can be selected (see
5.2.1 Changing the Items to
Procedure
1.
Anywhere in the menu structure, push the [FUNCT] button.
2.
To select the Control page, push the arrow buttons Up and Down. Go in with the [OK] button.
The Control page opens.
3.
If the Local control place and the keypad reference are used, P3.3.1.8 Keypad Reference can be set with the [OK] button.
26 | Danfoss A/S © 2023.08
6.3 Group 3.3:
References. If other control places or reference values are used, the
Monitor).
User Interfaces
AB298035655957en-000201 / DPD01083