Comparing The Parameters - Danfoss VACON 100 FLOW Series Application Manual

VACON® 100 FLOW
Application Guide

2.3.7 Comparing the Parameters

Use this function to compare the current parameter set with one of these 4 sets. See more about these parameters in
ter Back-up Parameters.
•
Set 1 (P6.5.4 Save to Set 1)
•
Set 2 (P6.5.6 Save to Set 2)
•
Defaults (P6.5.1 Restore Factory Defaults)
•
Keypad set (P6.5.2 Save to Keypad)
If the parameter set with which the current set is compared was not saved, the display shows the text Comparing failed.
Procedure
1.
Go into the User settings menu.
2.
Go into the Parameter Compare function.

STOP
Language Selection
Parameter Backup
Parameter Compare
3.
Select the pair of sets. Push [OK] to accept the selection.

STOP
Active set-Set 1
Active set-Set 2
Active set-Defaults
4.
Select Active and push [OK].
5. Examine the comparing between the current values and the values of the other set.

STOP
Active set-Set 1
Motor Nom Currnt
Motor Cos Phi
A
Danfoss A/S © 2023.08
N O T I C E
READY I/O
User Settings
ID: M6.6
English
(7)
(4)
READY I/O
Parameter Compare
ID: B6.6.1
READY I/O
ID:113
0.56A
1.90A
0.68
1.74
B C D
User Interfaces
9.1.2 Parame-
AB298035655957en-000201 / DPD01083 | 23