Changing The Control Place; Going Into The Control Page - Danfoss VACON 100 FLOW Series Application Manual

VACON® 100 FLOW
Application Guide

2.3.5.2 Changing the Control Place

This topic gives instructions on how to change the control place on the control panel.
Procedure
1. Anywhere in the menu structure, push the [FUNCT] button.
2. To select Local/Remote, use the arrow buttons Up and Down. Push the [OK] button.

STOP
Change direction
3. To select Local or Remote, use the arrow buttons Up and Down again. To accept the selection, push the [OK] button.

STOP
4.
If Remote control place is changed to Local, that is, Keypad, give a keypad reference.

After the selection, the display goes back into the same location where it was when the [FUNCT] button was push-
ed.

2.3.5.3 Going into the Control Page

It is easy to monitor the most important values in the Control page.
See more information about Keypad Reference in
display shows the frequency reference, which cannot be edited. The other values on the page are Multimonitor values. These values
can be selected (see 5.2.1 Changing the Items to
Procedure
1.
Anywhere in the menu structure, push the [FUNCT] button.
2.
To select the Control page, push the arrow buttons Up and Down. Go in with the [OK] button.

The Control page opens.
3. With the Local control place and the keypad reference selected, P3.3.1.8 Keypad Reference can be set with the [OK] button.
20 | Danfoss A/S © 2023.08
READY Keypad
Choose action
ID:1805
Control page
Local/Remote
READY Keypad
Local/Remote
ID:211
Local
Remote
6.3 Group 3.3:
Monitor).
References. If other control places or reference values are used, the
User Interfaces
AB298035655957en-000201 / DPD01083