Danfoss VACON 100 FLOW Series Application Manual page 227

VACON® 100 FLOW
Application Guide
A
B
ID716
E
F
Illustration 70: The Underload Time Counter Function
A Underload time counter
B Trip area
C
Trip/warning ID 713
11.11.5 Quick Stop
11.11.5.1 (ID 1276) Quick Stop Mode
Location in the menu: P3.9.5.1
Use this parameter to select how the drive stops when the quick stop command is given from DI or Fieldbus.
11.11.5.2 (ID 1213) Quick Stop Activation
Location in the menu: P3.9.5.2
Use this parameter to select the digital input signal that activates a Quick Stop function. The Quick Stop function stops the drive
regardless of the control place or the state of the control signals.
11.11.5.3 (ID 1256) Quick Stop Deceleration Time
Location in the menu: P3.9.5.3
Use this parameter to set the time that is necessary for the output frequency to decrease from maximum frequency to 0 when a
quick stop command is given. The value of this parameter is applied only when the quick stop mode parameter is set to 'Quick Stop
Deceleration time'.
11.11.5.4 (ID 744) Response to Quick Stop Fault
Location in the menu: P3.9.5.4
Use this parameter to select the response of the drive to a 'Quick Stop' fault. If the quick stop command is given from DI or Fieldbus,
a quick stop fault occurs.
With the quick stop function, it is possible stop the drive in an unusual procedure from I/O or Fieldbus in unusual conditions. When
the quick stop function is active, it is possible make the drive decelerate and stop. It is possible to program an alarm or fault to put a
mark in the fault history that there was a request for a quick stop.
Do not use the quick stop function as an emergency stop. An emergency stop must stop the power supply to the motor. The
quick stop function does not do this.
Danfoss A/S © 2023.08
C
D
C A U T I O N
D Time
E Underload
F No underload
AB298035655957en-000201 / DPD01083 | 227
Parameter Descriptions