Danfoss VACON 100 FLOW Series Application Manual page 197

VACON® 100 FLOW
Application Guide
2. In the Edit mode, the letter D blinks. If there are more digital inputs available in the I/O, for example, because of option
boards in slots C, D or E, select them.

3.
To activate the terminal 3, push the arrow button Right again. The letter D stops blinking.
4. To change the terminal to 6, push the arrow button Up 3 times. Accept the change with the [OK] button.

5. If the digital input DI6 was already used for some other function, a message scrolls on the display. Change one of these
selections.
It is also possible to give time channels to digital inputs. There is more data about it in

After the steps, a digital signal to the digital input DI6 controls the function External Fault Close. The value of a
function can be DigIN Slot0.1 (in the graphical display) or dI 0.1 (in the text display). In these conditions, a terminal
was not given to the function, or the input was set to be always OPEN. It is the default value of most of parameters
in the group M3.5.1. On the other hand, some inputs have the default value always CLOSED. Their value shows
DigIN Slot0.2 in the graphical display and dI 0.2 in the text display.
11.7.1.5 Programming of Analog Inputs
It is possible to select the target input for the signal of the analog frequency reference from the available analog inputs.
A
READY
STOP
Analog Input 1
ID:377 P3.5.2.1.1
AI1 Signal Sel
AnINSlotA.1
AI1 Filter Time
AIl Signal Range
0-10V/0-20mA
Illustration 54: The Analog Inputs Menu in the Graphical Display
Danfoss A/S © 2023.08
B
I/O
0.10s
C
Parameter Descriptions
Table 79.
AB298035655957en-000201 / DPD01083 | 197