Basic - Danfoss VACON 100 FLOW Series Application Manual

VACON® 100 FLOW
Application Guide
10.1.9 (ID 6) Motor Voltage
• Location in the menu with default settings: V2.1.9 (In Multimonitor menu)
•
Location in the menu: V2.3.9 (In Basic menu)
This monitoring value shows the actual output voltage to the motor.

10.2 Basic

10.2.1 (ID 1) Output Frequency
• Location in the menu with default settings: V2.1.2 (In Multimonitor menu)
• Location in the menu: V2.3.1 (In Basic menu)
This monitoring value shows the actual output frequency to the motor.
10.2.2 (ID 25) Frequency Reference
• Location in the menu with default settings: V2.1.1 (In Multimonitor menu)
• Location in the menu: V2.3.2 (In Basic menu)
This monitoring value shows the actual frequency reference to the motor control.
The value is updated at 10 ms interval.
10.2.3 (ID 2) Motor Speed
• Location in the menu with default settings: V2.1.4 (In Multimonitor menu)
• Location in the menu: V2.3.3 (In Basic menu)
This monitoring value shows the actual speed of the motor in RPM (calculated value).
10.2.4 (ID 3) Motor Current
• Location in the menu with default settings: V2.1.3 (In Multimonitor menu)
• Location in the menu: V2.3.4 (In Basic menu)
This monitoring value shows the measured current of the motor.
The scaling of the value is different for different drive sizes.
10.2.5 (ID 4) Motor Torque
• Location in the menu with default settings: V2.1.8 (In Multimonitor menu)
• Location in the menu: V2.3.5 (In Basic menu)
This monitoring value shows the actual torque of the motor (calculated value).
10.2.6 (ID 5) Motor Shaft Power
• Location in the menu with default settings: V2.1.5 (In Multimonitor menu)
• Location in the menu: V2.3.7 (In Basic menu)
This monitoring value shows the actual shaft power of the motor (calculated value) as a percentage of the motor nominal power.
10.2.7 (ID 73) Motor Shaft Power
Location in the menu: V2.3.8
This monitoring value shows the actual shaft power of the motor (calculated value). The unit of measurement is kW or hp, depend-
ing on parameter kW/hp Selection (ID 1198) value.
The number of decimals in the value of this monitoring value varies depending on the size of the AC drive. In fieldbus control, ID
15592 can be mapped as Process Data Out to determine how many decimals are used. The last significant digit tells the amount of
decimals.
152 | Danfoss A/S © 2023.08
Monitoring Value Descriptions
AB298035655957en-000201 / DPD01083