External Pid Controller; Multi-Pump - Danfoss VACON 100 FLOW Series Application Manual

VACON® 100 FLOW
Application Guide
Monitoring Value Descriptions
10.7.7 (ID 24) PID Status
Location in the menu: V2.8.7
This monitoring value shows the state of the PID controller.

10.8 External PID Controller

10.8.1 (ID 83) EXTPID Setpoint
Location in the menu: V2.9.1
This monitoring value shows the value of the PID setpoint signal in process units. Use the parameter P3.14.1.10 to select the process
unit (See 11.15.1.7 (ID 1035) Process Unit Decimals).
10.8.2 (ID 85) EXTPID Error
Location in the menu: V2.9.3
This monitoring value shows the error value of the PID controller. The error value is the deviation of PID feedback from the PID
setpoint in process unit. Use the parameter P3.14.1.10 to select the process unit (See 11.15.1.7 (ID 1035) Process Unit Decimals).
10.8.3 (ID 84) EXTPID Feedback
Location in the menu: V2.9.2
This monitoring value shows the value of the PID feedback signal in process units. Use the parameter P3.14.1.10 to select the proc-
ess unit (See 11.15.1.7 (ID 1035) Process Unit Decimals).
10.8.4 (ID 86) EXTPID Output
Location in the menu: V2.9.4
This monitoring value shows the output of the PID controller as a percentage (0–100%). Give this value to, for example, the analog
output.
10.8.5 (ID 87) EXTPID Status
Location in the menu: V2.9.5
This monitoring value shows the state of the PID controller.

10.9 Multi-pump

10.9.1 (ID 30) Motors Running
Location in the menu: V2.10.1
This monitoring value shows the actual number of motors that operate in the Multi-pump system.
10.9.2 (ID 1114) Autochange
Location in the menu: V2.10.2
This monitoring value shows the status of the autochange requested.
10.9.3 (ID 1503) Next Autochange
Location in the menu: V2.10.3
This monitoring value shows the time that remains to next autochange.
10.9.4 (ID 1505) Operate Mode
Location in the menu: V2.10.4
This monitoring value shows the operation mode of the drive in the Multi-pump system.
10.9.5 (ID 1628) Multi-pump Status
Location in the menu: V2.10.5
This monitoring value shows the status of the drive in the Multi-pump system.
158 | Danfoss A/S © 2023.08 AB298035655957en-000201 / DPD01083