Danfoss VACON 100 FLOW Series Application Manual page 107

VACON® 100 FLOW
Application Guide
Index Parameter
P3.9.4.2 Underload Protection: Field Weakening
Area Load
P3.9.4.3 Underload Protection: Zero Frequency
Load
P3.9.4.4 Underload Protection: Time Limit
Table 61: Quick Stop Settings
Index Parameter
P3.9.5.1 Quick Stop Mode
P3.9.5.2 Quick Stop Activation
P3.9.5.3 Quick Stop Deceleration
Time
P3.9.5.4 Response to Quick Stop
Fault
Table 62: Temperature Input Fault 1 Settings
Index Parameter
P3.9.6.1
(1)
Temperature Signal 1
P3.9.6.2
(1)
Alarm Limit 1
P3.9.6.3
(1)
Fault Limit 1
P3.9.6.4
(1)
Fault Limit Response 1
Temperature input settings are only available if a B8 or BH option board is installed.
1
Danfoss A/S © 2023.08
Min Max
10.0 150.0
5.0 150.0
2.00 200.00
Min Max Unit Default
0 2 Varies
Varies Varies DigIN Slot0.2
0.1 300.0 s Varies
0 2 Varies
Min Max Unit Default
0 63 0
-30.0 200.0 °C 130.0
-30.0 200.0 °C 155.0
0 3 2
Unit Default ID Description
3 = Fault (Stop by coasting)
% 50.0 714
% 10.0 715
s 20.00 716
ID Description
1276 0 = Coasting
1 = Quick stop deceleration time
2 = Stop according to Stop function
(P3.2.5)
1213 OPEN = Activated
1256
744 0 = No action
1 = Alarm
2 = Fault (Stop according to Quick stop
mode)
ID Description
739 B0 = Temperature Signal 1
B1 = Temperature Signal 2
B2 = Temperature Signal 3
B3 = Temperature Signal 4
B4 = Temperature Signal 5
B5 = Temperature Signal 6
741
742
740 0 = No response
1 = Alarm
2 = Fault (Stop according to stop mode)
3 = Fault (Stop by coasting)
AB298035655957en-000201 / DPD01083 | 107
Parameters Menu