Danfoss VACON 100 FLOW Series Application Manual page 289

Hide thumbs Also See for VACON 100 FLOW Series:
Table of Contents

Advertisement

VACON® 100 FLOW
Application Guide
11.24.9.35 (ID 3581) Load Warning S1 Counter
Location in the menu: P3.24.5.3.1
Use this parameter to set warning S1 counter value.
11.24.9.36 (ID 3582) Load Warning S2 Counter
Location in the menu: P3.24.5.3.2
Use this parameter to set warning S2 counter value.
11.24.9.37 (ID 3583) Load Alarm/Fault Counter
Location in the menu: P3.24.5.3.3
Use this parameter to set alarm/fault counter value.
11.24.9.38 (ID 3584) Load Warning S1 Low
Location in the menu: P3.24.5.2.2
Use this parameter to set the threshold value for computing the warning 1 low notification threshold. Threshold value range varies
based on warning mode selection. This limit is not used when value is zero.
11.24.9.39 (ID 3585) Load Warning S2 Low
Location in the menu: P3.24.5.2.6
Use this parameter to set the threshold value for computing the warning 2 low notification threshold. Threshold value range varies
based on warning mode selection. This limit is not used when value is zero.
11.24.9.40 (ID 3586) Load Alarm/Fault Low
Location in the menu: P3.24.5.2.10
Use this parameter to set the threshold value for computing the alarm/fault low notification threshold. Threshold value range varies
based on warning mode selection. This limit is not used when value is zero.
11.24.10 (ID 3587) Vibration Input
Location in the menu: P3.24.4.1
Use this parameter to select the analog input to vibration.
11.25 Default Values of Parameters in the Different Applications
Table 132: Default Values of Parameters of Group 3.2
Index
Parameter
3.2.1
Rem Control
Place
3.2.2
Local/Remote
3.2.6
I/O A Logic
3.2.7
I/O B Logic
Danfoss A/S © 2023.08
Standard
HVAC ap-
PID con-
applica-
plication
trol ap-
tion
plication
0
0
0
0
0
0
2
2
2
2
2
2
Multi-pump
Multi-pump
(single
(multidrive)
drive) appli-
application
cation
0
0
0
0
0
0
2
2
AB298035655957en-000201 / DPD01083 | 289
Parameter Descriptions
Unit
ID
Description
172
0 = I/O Control
211
0 = Remote
300
2 = Forw-Back
(edge)
363
2 = Forw-Back
(edge)

Advertisement

Table of Contents
loading

Table of Contents