Danfoss VACON 100 FLOW Series Application Manual page 205

VACON® 100 FLOW
Application Guide
Use this parameter to select the digital input signal that is used as interlock signal for the Multi-pump system. The selection of the
application with parameter P1.2 Application gives the default value.
11.7.4.48 (ID 1053) Reset kWh Trip Counter
Location in the menu: P3.5.1.52
Use this parameter to select the digital input signal that resets the kWh Trip Counter.
11.7.4.49 (ID 496) Parameter Set 1/2 Selection
Location in the menu: P3.5.1.53
Use this parameter to set the digital input that selects the parameter set to be used. This function is enabled if any other slot than
'DigIN Slot0' is selected to this parameter. The parameter set selection is allowed only when the drive is stopped.
• Contact Open = Parameter Set 1 is loaded as the active set
• Contact Closed = Parameter Set 2 is loaded as the active set
Parameter values are stored to Set 1 and Set 2 by parameters B6.5.4 Save to Set 1 and B6.5.4 Save to Set 2. These parameters can be
used either from keypad or VACON
11.7.4.50 (ID 15576) Multi-setpoint Selection 0
Location in the menu: P3.5.1.54
Use this parameter to select the digital input signal that is used as a selector for the PID Multi-setpoint function.
11.7.4.51 (ID 15577) Multi-setpoint Selection 1
Location in the menu: P3.5.1.55
Use this parameter to select the digital input signal that is used as a selector for the PID Multi-setpoint function.
11.7.4.52 (ID 15578) Multi-setpoint Selection 2
Location in the menu: P3.5.1.56
Use this parameter to select the digital input signal that is used as a selector for the PID Multi-setpoint function.
11.7.4.53 (ID 15579) Multi-setpoint Selection 3
Location in the menu: P3.5.1.57
Use this parameter to select the digital input signal that is used as a selector for the PID Multi-setpoint function.
11.7.4.54 (ID 15590) Flow Switch
Location in the menu: P3.5.1.58
Use this parameter to select the digital input signal that is the feedback signal from the Flow Switch.
11.7.4.55 (ID 15513) AHF Over Temperature
• Location in the menu: P3.5.1.59 (In I/O Configuration parameter menu)
• Location in the menu: P3.23.3 (In Advanced Harmonic Filter parameter menu)
Use this parameter to set the digital input signal that activates AHF Over Temp (fault ID 1118).
11.7.5 Analog Inputs
11.7.5.1 (ID 377) AI1 Signal Selection
Location in the menu: P3.5.2.1.1
Use this parameter to connect the AI signal to the analog input of your selection.
This parameter is programmable. See
11.7.5.2 (ID 378) AI1 Signal Filter Time
Location in the menu: P3.5.2.1.2
Use this parameter to filter out disturbances in the analog input signal. To activate this parameter, enter a value greater than 0.
Danfoss A/S © 2023.08
Live PC tool.
®
11.7.3 Default Functions of Programmable
Parameter Descriptions
Inputs.
AB298035655957en-000201 / DPD01083 | 205