Trip Counters - Danfoss VACON 100 FLOW Series Application Manual

VACON® 100 FLOW
Application Guide
Index Parameter
V4.4.6 Operating Time (text
keypad)
V4.4.7 Run Time (graphical key-
pad)
V4.4.8 Run Time (text keypad)
V4.4.9 Run Time (text keypad)
V4.4.10 Run Time (text keypad)
V4.4.11 Power On Time (graphi-
cal keypad)
V4.4.12 Power On Time (text
keypad)
V4.4.13 Power On Time (text
keypad)
V4.4.14 Power On Time (text
keypad)
V4.4.15 Start Command Counter

7.2.3 Trip Counters

Table 108: The Trip Counter Parameters in the Diagnostics Menu
Index Parameter
P4.5.1 Energy Trip Counter
P4.5.3 Operating Time
(graphical keypad)
P4.5.4 Operating Time
(text keypad)
P4.5.5 Operating Time
(text keypad)
P4.5.6 Operating Time
(text keypad)
138 | Danfoss A/S © 2023.08
Min Max Unit
hh:min:ss
a d hh:min
a
d
hh:min:ss
a d hh:min
a
d
hh:min:ss
Min Max Unit De-
fault
Varies
a d hh:min
a
d
hh:min:ss
De- ID Description
fault
The operating time of the control unit in hours,
minutes, and seconds.
2293 The motor run time.
The motor run time in total years.
The motor run time in total days.
The motor run time in hours, minutes, and sec-
onds.
2294 The quantity of time that the power unit has
been powered on. The counter cannot be reset.
The power on time in total years.
The power on time in total days.
The power on time in hours, minutes, and sec-
onds.
2295 The number of times that the power unit has
been started.
ID Description
2296
This counter can be reset. In the text display: the high-
est energy unit that the display shows is MW. If the
counted energy becomes more than 999.9 MW, no
unit shows on the display.
Resetting the counter:
• In the text display: Push the [OK] button for 4 s.
• In the graphical display: Push [OK]. A Reset coun-
ter page shows. Push [OK] again.
2299 This counter can be reset. See instructions in P4.5.1.
The operating time in total years.
The operating time in total days.
The operating time in hours, minutes, and seconds.
Diagnostics Menu
AB298035655957en-000201 / DPD01083