Danfoss VACON 100 FLOW Series Application Manual page 219

VACON® 100 FLOW
Application Guide
Parameter Descriptions
11.10 Supervisions
11.10.1 (ID 1431) Supervision #1 Item Selection
Location in the menu: P3.8.1
Use this parameter to select the supervision item. The output of the supervision function can be selected to the relay output.
11.10.2 (ID 1432) Supervision #1 Mode
Location in the menu: P3.8.2
Use this parameter to set the supervision mode.
When the 'Low limit' mode is selected, the output of the supervision function is active when the signal is below the supervision
limit.
When the 'High limit' mode is selected, the output of the supervision function is active when the signal is above the supervision
limit.
11.10.3 (ID 1433) Supervision #1 Limit
Location in the menu: P3.8.3
Use this parameter to set the supervision limit for the selected item. The unit shows automatically.
11.10.4 (ID 1434) Supervision #1 Limit Hysteresis
Location in the menu: P3.8.4
Use this parameter to set the supervision limit hysteresis for the selected item. The unit shows automatically.
11.10.5 (ID 1435) Supervision #2 Item Selection
Location in the menu: P3.8.5
Use this parameter to select the supervision item. The output of the supervision function can be selected to the relay output.
11.10.6 (ID 1436) Supervision #2 Mode
Location in the menu: P3.8.6
Use this parameter to set the supervision mode.
11.10.7 (ID 1437) Supervision #2 Limit
Location in the menu: P3.8.7
Use this parameter to set the supervision limit for the selected item. The unit shows automatically.
11.10.8 (ID 1438) Supervision #2 Limit Hysteresis
Location in the menu: P3.8.8
Use this parameter to set the supervision limit hysteresis for the selected item. The unit shows automatically.
11.11 Protections
11.11.1 General
11.11.1.1 (ID 701) Response to External Fault
Location in the menu: P3.9.1.2
Use this parameter to select the response of the drive to an 'External Fault'.
If a fault occurs, the drive can show a notification of it on the display of the drive. An external fault is activated with a digital input
signal. The default digital input is DI3. It is also possible to program the response data into a relay output.
11.11.1.2 (ID 730) Input Phase Fault
Location in the menu: P3.9.1.3
Use this parameter to select the supply phase configuration of the drive.
If the 1-phase supply is used, the value of this parameter must be set to 1-phase support.
Danfoss A/S © 2023.08 AB298035655957en-000201 / DPD01083 | 219