Trend Curve Parameters; Basic Monitoring; Uses Of The Basic Monitoring - Danfoss VACON 100 FLOW Series Application Manual

VACON® 100 FLOW
Application Guide
RUN
Motor Current
Motor Speed
2. Push [OK] at the target point of the curve.

A vertical line comes into view on the display. The values at the bottom of the display agree to the location of the
line.
RUN
Motor Current
Motor Speed
3.
To move the line to see the values of some other location, use the arrow buttons Left and Right.

5.3.4 Trend Curve Parameters

Table 13: The Trend Curve Parameters
Index Parameter
M2.2.1 View Trend curve
P2.2.2 Sampling interval
P2.2.3 Channel 1 min
P2.2.4 Channel 1 max
P2.2.5 Channel 2 min
P2.2.6 Channel 2 max
P2.2.7 Autoscale

5.4 Basic Monitoring

5.4.1 Uses of the Basic Monitoring

Only the standard I/O board statuses are available in the Monitor menu. For the statuses of all the I/O board signals as raw data, see
the I/O and Hardware menu.
Danfoss A/S © 2023.08
READY ALARM I/O
0.02A
-317rpm
READY ALARM I/O
0.01A
-252rpm
Min Max Unit Default
100 432000 ms 100
-214748 1000 -1000
-1000 214748 1000
-214748 1000 -1000
-1000 214748 1000
0 1 0
ID Description
Go into this menu to monitor values in a curve form.
2368
2369
2370
2371
2372
2373
0 = Disabled
1 = Enabled
AB298035655957en-000201 / DPD01083 | 77
Monitor Menu