KIP 9000 Service Manual page 693

8. 2. 4 User Mode 4
(Cold Sleep Mode timer setting)
[Function]
It is possible to set the Cold Sleep timer. If the KIP 9000 does not receive any print/copy for the
time set as timer in User Mode 4, it will go into the Cold Sleep Mode to save the power
consumption.
Reference
Cold Sleep Mode is a kind of power saving mode that can save more power than Warm Sleep
Mode. It works when the KIP9000 does not print for the time the timer specifies. Power
consumption is reduced greatly by completely shutting off supplying the power to the fuser
unit. The Cold Sleep Mode will be cancelled automatically when a print job or a copy job is
sent from the outer device. However it may take time until the KIP9000 starts printing as it
needs to recover enough temperature on the fuser. (Print does not start until the KIP9000 gets
ready recovering enough temperature.) Note that the Cold Sleep Mode will require longer
recovering time than Warm Sleep.
NOTE
If the Cold Sleep does not start even if the time specified in
User Mode 4 has passed, the Cold Sleep Mode may be set to
OFF. If there is a dot beside the timer value, the Cold Sleep
Mode is set to OFF (inactive).
To set the Cold Sleep to ON, see [(11) Cold Sleep ON/OFF
(No.0C)] on page 8-57.
[Operation]
1. Press the [ MENU ] Key 4 times to select the User Mode 4. [ MENU ] Key lights green and the
Status Display indicates "U4.".
MENU ENTER ONLINE
Press [ MENU ] 4 times.
MENU ENTER ONLINE
8-168
MENU ENTER ONLINE
Dot (Cold Sleep is OFF)
K115sm8e5.doc