KIP 9000 Service Manual page 577

getting a proper print result. So he needs to have 2 different fuser temperature settings for
getting satisfactory result in both cases, one for recommended paper (Standard Setting
Value) and another for special paper (Special Setting Value).
NOTE
(1) It is not recommended to change the "Standard Setting Value" as it is the best factory
setting, but it is possible to do it if necessary. Preferably backup all the Standard Setting
Value before change.
(2) Refer to each setting item list to know which items of Adjustment Mode 0/1 are "dual value
items".
[8.1.5.4 Setting item list] on and after the page 8-39
[8.1.6.4 Setting item list] on and after the page 8-89
If "OK" is provided in [Special setting] column of the list, this item is a "dual value item".
If "NO", it is a "single value item".
(3) Switch between "Standard Setting Value" and "Special Setting Value" can be done in the
User Modes 8, 9 and A.
If you set the User Mode to [Standard Print Mode], the "Standard Setting Value" of all dual
value items become active.
If you set the User Mode to [Special Print Mode], the "Special Setting Value" of all dual
value items become active.
Refer to the following pages for the detail of User Modes 8, 9 and A.
[8.2.8 User Mode 8] (Page 8-180)
[8.2.9 User Mode 9] (Page 8-184)
[8.2.10 User Mode A] (Page 8-188)
(4) On every dual value item, its "Standard Setting Value" and "Special Setting Value" are set
to the same value when shipped from factory.
8-52 K115sm8e2.doc