6. Using the slit (8) on each drawer, cut off the leading part of roll media with a cutter knife to
straighten the leading edge.
DO NOT FEED ANY TAPE OR ADHESIVE INTO THE MACHINE AS IT MAY STICK TO THE DRUM.
It is best to trim at least one revolution from the roll to prevent this. Please advise the users
8
7. Insert the leading edge of media between feeding rollers (9), and rotate the upper feeding roller
to pinch the leading edge (1-2cm) with the rollers.
9
NOTE
The Roll Deck 3 only has a positioning hole (10). (Other Rolls do not have it.)
Feed the roll media until its leading edge comes to appear in the hole, and place the leading
edge at the center of the hole.
10
2-53